Jurome
Well-known member
Any tips for welding onto the Zuk frame? I am getting prepared for the frame reinforcements and am thinking about practicing some more "thick to thin" beads before I commit. I have a really good Miller MIG and thanks to YouTube and much practice I have made some huge improvements. Welding on the flat I am very confident but have only a handful of vertical weld tasks under my belt. On some practice rounds I have been keeping the bead into the thicker metal to avoid burning though the thinner material with really good results...albeit, practicing with the material laid flat. If it is flat I can make it look like a stack of dimes...on the vertical...well...
Is it OK to weld the plates on the frame in a downhill direction? I'm not too worried about penetration since the material is so thin.
Any other tips and/or suggestions welcomed.
Is it OK to weld the plates on the frame in a downhill direction? I'm not too worried about penetration since the material is so thin.
Any other tips and/or suggestions welcomed.