G and W series bellhousing locating dowel measurements

[TDIZook]

Since I have never seen these measurements on the interwebs, I thought that someone may appreciate this.
This is for a 22RE Toyota G and W series bellhousing.

 

[k1n3k]

Many thanks! How did you measure it? Plop the block on the mill and indicate it with the DRO?

 

[TDIZook]

Many thanks! How did you measure it? Plop the block on the mill and indicate it with the DRO?

UR welcome 
The fact that this measurement was nowhere to be found on the internet
when I was trying to make my own adapter led to many frustrations and
a worn out input shaft bearing because of excess run out.
Yep,I used an edge finder and DRO on the mill.
Cut the old block in half with a grinder then milled it flat.

 

[Aids10]

Zu Copy

View attachment 22-RE-Locating-Pin-Locations.webp