norzuki
Well-known member
Soooo...........you want to keep that handle in place so it won't rattle and slap everything on your rig?
Here is a CHEAP & Simple solution:
Step #1
Go and buy yourself a small "POLY" cutting board
Step #2
take the poly cutting board and put it flush on the TOP end of the high lift tower. Trace around the very top of the tower.
Step #3
then take the Jack Handle and move it about 1/2 inch above the trace you made of the tower.
Step #4
Use some kind of cutting device. I used a Dremel Tool with a cutting bit. Cut on the inside of the trace marks...........this will give you the snug fit .......... you can always trim to fit if needed.
And you end up with something like this:
Here is a CHEAP & Simple solution:
Step #1
Go and buy yourself a small "POLY" cutting board
Step #2
take the poly cutting board and put it flush on the TOP end of the high lift tower. Trace around the very top of the tower.
Step #3
then take the Jack Handle and move it about 1/2 inch above the trace you made of the tower.
Step #4
Use some kind of cutting device. I used a Dremel Tool with a cutting bit. Cut on the inside of the trace marks...........this will give you the snug fit .......... you can always trim to fit if needed.
And you end up with something like this:
![high_lift_mod.jpg](/proxy.php?image=http%3A%2F%2Fbbs.zuwharrie.com%2Fgallery%2Falbums%2Fuserpics%2F10108%2Fhigh_lift_mod.jpg&hash=9df92fe189337bb91dbe04be02e40e59)
![high_lift_mod01.jpg](/proxy.php?image=http%3A%2F%2Fbbs.zuwharrie.com%2Fgallery%2Falbums%2Fuserpics%2F10108%2Fhigh_lift_mod01.jpg&hash=220089a332d85bbac9f53f9151fdade9)
![high_lift_mod02.jpg](/proxy.php?image=http%3A%2F%2Fbbs.zuwharrie.com%2Fgallery%2Falbums%2Fuserpics%2F10108%2Fhigh_lift_mod02.jpg&hash=17cdffcb80641d087a7a779434dc027b)
![high_lift_mod03.jpg](/proxy.php?image=http%3A%2F%2Fbbs.zuwharrie.com%2Fgallery%2Falbums%2Fuserpics%2F10108%2Fhigh_lift_mod03.jpg&hash=f83a42d3437c3a55a3bceab386af8b35)