Skip to main content

Topic: Wiring Tacometer (ALL NEW WIRING) (Read 1435 times) previous topic - next topic

0 Members and 1 Guest are viewing this topic.
  • norzuki
  • [*][*][*][*][*]
  • Moderator
  • The Deer Stalker
Wiring Tacometer (ALL NEW WIRING)
Guys ... this isn't a real "How To" but I felt it necessary to put this in here for anyone that might want to COMPLETELY rewire their Zuk ... that means all old wiring gone including the (2) plugs that go in the back of the gauge cluster.

With the very good help of Darrell ( aka: overthepond66 ) ..... I managed to figure out how to wire the Tach using the (3) screws in the back of the gauge cluster (the screws that hold the Tach in place)



Explanation:
Look at the back of your gauge cluster. There are (3) screws directly behind the Tachometer that are in a row straight up and down. These will be the (3) screws you will use.



From top to bottom:
Top Screw = Wire to (-) side of Coil
Middle Screw = Wire to Ground chassis
Bottom Screw = (+) to Ignition
and thats it [thumbsup]


Loud Proud & Country By The Grace Of God !!!

  • beekiller
  • [*][*][*][*][*]
  • Administrator
  • Krew Krawlers, Mountain Division
Re: Wiring Tacometer (ALL NEW WIRING)
Reply #1
Sure it's a great how to!  Nice write up!
All I want from tomorrow is to get it better than today.

Claiming you are offended is essentially saying you are incapable of controlling and managing your emotions, so everyone else should do it for you.

  • norzuki
  • [*][*][*][*][*]
  • Moderator
  • The Deer Stalker
Re: Wiring Tacometer (ALL NEW WIRING)
Reply #2
Thank Bryan ..

maybe this will help someone in the future ;D
Loud Proud & Country By The Grace Of God !!!